Cisco 200-301

Choose your answer

• A

  If a monitored port exceeds the maximum administrative value for power, the port is shutdown and err-disabled.

• B

  When a powered device begins drawing power from a PoE switch port, a syslog message is generated.

• C

  As power usage on a PoE switch port is checked, data flow to the connected device is temporarily paused.

• D

  If a switch determines that a device is using less than the minimum configured power, it assumes the device has failed and disconnects it.

Pick an answer to check it, or press Show answer to see the correct one.

Choose your answer

• A

  Frames are sent to all ports, including those that are assigned to other VLANs.

• B

  Frames are sent to every port on the switch that has a matching entry in MAC address table.

• C

  Frames are sent to every port on the switch in the same VLAN except from the originating port.

• D

  Frames are sent to every port on the switch in the same VLAN.

Pick an answer to check it, or press Show answer to see the correct one.

Choose your answer

• A

  allows multiple companies to each use the same addresses without conflicts

• B

  provides a direct connection for hosts from outside of the enterprise network

• C

  ensures that NAT is not required to reach the Internet with private range addressing

• D

  enables secure communications to the Internet for all external hosts

Pick an answer to check it, or press Show answer to see the correct one.

Choose your answer

• A

  explicitly assign a link-local address

• B

  disable the EUI-64 bit process

• C

  enable SLAAC on an interface

• D

  configure a stateful DHCPv6 server on the network

Pick an answer to check it, or press Show answer to see the correct one.

Choose your answer

• A

  5GHz provides increased network capacity with up to 23 nonoverlapping channels.

• B

  5GHz channel selection requires an autonomous access point.

• C

  Cells that overlap one another are configured to use nonoverlapping channels.

• D

  Adjacent cells with overlapping channels use a repeater access point.

• E

  For maximum throughput, the WLC is configured to dynamically set adjacent access points to the channel.

Pick an answer to check it, or press Show answer to see the correct one.